 |
 |
 |
|
| Custom fit your regulator with this moldable mouthpiece. Simply heat in hot water, bite down, and you have a personalized mouthpiece. This piece is named Sea Cure, because its fit increases comfort and lowers jaw fatigue. Make sure you specify your Size based on your individual regulator. See chart below! |
|
|
|
|
|
 |
|
 |
|
Features
| SeaCureSize |
Manufacturer and Style |
| I |
Fits standard orifice regulators that have a conventional mouthpiece retention lip.
APOLLO, AQUA LUNG older metal regulators, ATOMIC, BEUCHAT Evolution,iceberg and Nitrox, VXT8, VXT Octo, VX4, BRIDGESTONE, CRESSI-SUB (exceptEllipse uses a Pro II- pull out the yellow insert), DACOR after 1992(cannot use with Aero), DIVE BUDDY, IST (except Proline is a II), NDS,OCEAN MASTER, PRO SUB, SAEKO-LINE, SAS, SCUBA PRO, SEAC, SHERWOOD (most early models/ Brut/Shadow/ Magnum II/ Oasis/ pre 1992 Blizzard), TABATA/TUSA (not TUSA Imprex) |
| II |
Fits intermediate size air orifice regulators.
ABYSS Explorer, AERIS, APEKS (ATX 200 works better with a Pro II), AQUALUNG Titan or Legend, BEUCHAT VS8,VS4,VS3,VX10, DACOR Viper or Eagle,DIVE RITE, FORTE, HALCYON REBREATHER, MARES newer models (but not MARESMR 12 II,III,IV or V), OCEAN EDGE, OCEAN REEF, OCEANIC (not Zeta),ODYSSEY, SCUBA MAX, SEAQUEST, SHERWOOD (Maximus,Oasis, 2/92 and newerBlizzard), SPORASUB, XS SCUBA (Osprey is a I), ZEAGLE |
| III |
AQUA LUNG older plastic regulators including Micra (these regulators do not have theconventional retention lip on the mouthpiece orifice common to all other regulators and therefore no other SeaCure model should be used), AQUATEC,GENESIS, SEA MECH |
| not listed above |
If not sure of the correct size, simply measure the retention lip on the air orifice of the regulator. Or, if possible, try both SeaCure I and SeaCure II on the unit in question to see which fits. Almost all regulators fall into two general sizes with some in each group being slightly larger or smaller than the average.
Standard Lip: (1 1/4 in x _in ) takes a SeaCure I
Oversize Lip: (1 7/16 x 7/8in) takes a SeaCure II |
|
|
|
 |
|
 |
|
