Seac-Sub Asso Pneumatic Speargun without Power Reducer has an aluminum alloy cylinder with a 40 mm diameter. Light alloy muzzle with increased holes to optimize the discharge of water the 13 mm diameter allows the use of an 8 mm spear. Comes with: steel spear, pump, Tip, Loader, line, carrying case.

Pneumatic Spearguns utilize the energy from compressed air stored in the barrel. They are usually more powerful than banded Spearguns of the same length. When the shaft is pushed into the barrel, it compresses the air and builds up pressure.

No Pumping is required between shots. Pumping air into the barrel with the pump supplied is only necessary if the working pressure has been reduced by expelling air i.e expelling air from the gun due to air travel etc. Most spear fisherman set the power / pressure at the start of the season - and that’s it! No more pressure setting or pumping should be necessary.

The ASSO is factory assembled with an internal air pressure of 20 bars (285 PSI). Warning : in case of re-loading do not ever exceed the 20 BAR.

To load an Asso you should lean the handgrip against your thigh or foot, according to the length, after inserting the tang of the shaft in the muzzle; drive the shaft to the end towards the handgrip until the piston is hooked to the click tooth (when the hook has taken place, one can hear the "click" of the tooth itself). Now the gun is ready for firing: slide the safety to the fire position and pull the trigger to shoot.

• Tank: aluminum alloy cylinder with a 40 mm diameter.
• Butt: Light alloy muzzle with increased holes to optimize the discharge of water.
• Handle: ergonomic and functional form. Made in one material.
• Barrel: the 13 mm diameter allows the use of an 8 mm spear.
• Comes with: steel spear, injector, harpoon, harpoon loader.

Seac Spare Part Catalogue

Seac-Sub Asso Pneumatic Speargun without Power Reducer has an aluminum alloy cylinder with a 40 mm diameter. Light alloy muzzle with increased holes to optimize the discharge of water the 13 mm diameter allows the use of an 8 mm spear. Comes with: steel spear, pump, Tip, Loader, line, carrying case.

Pneumatic Spearguns utilize the energy from compressed air stored in the barrel. They are usually more powerful than banded Spearguns of the same length. When the shaft is pushed into the barrel, it compresses the air and builds up pressure.

No Pumping is required between shots. Pumping air into the barrel with the pump supplied is only necessary if the working pressure has been reduced by expelling air i.e expelling air from the gun due to air travel etc. Most spear fisherman set the power / pressure at the start of the season - and that’s it! No more pressure setting or pumping should be necessary.

The ASSO is factory assembled with an internal air pressure of 20 bars (285 PSI). Warning : in case of re-loading do not ever exceed the 20 BAR.

To load an Asso you should lean the handgrip against your thigh or foot, according to the length, after inserting the tang of the shaft in the muzzle; drive the shaft to the end towards the handgrip until the piston is hooked to the click tooth (when the hook has taken place, one can hear the "click" of the tooth itself). Now the gun is ready for firing: slide the safety to the fire position and pull the trigger to shoot.

• Tank: aluminum alloy cylinder with a 40 mm diameter.
• Butt: Light alloy muzzle with increased holes to optimize the discharge of water.
• Handle: ergonomic and functional form. Made in one material.
• Barrel: the 13 mm diameter allows the use of an 8 mm spear.
• Comes with: steel spear, injector, harpoon, harpoon loader.

Seac-Sub Asso Pneumatic Speargun without Power Reducer has an aluminum alloy cylinder with a 40 mm diameter. Light alloy muzzle with increased holes to optimize the discharge of water the 13 mm diameter allows the use of an 8 mm spear. Comes with: steel spear, pump, Tip, Loader, line, carrying case.

Pneumatic Spearguns utilize the energy from compressed air stored in the barrel. They are usually more powerful than banded Spearguns of the same length. When the shaft is pushed into the barrel, it compresses the air and builds up pressure.

No Pumping is required between shots. Pumping air into the barrel with the pump supplied is only necessary if the working pressure has been reduced by expelling air i.e expelling air from the gun due to air travel etc. Most spear fisherman set the power / pressure at the start of the season - and that’s it! No more pressure setting or pumping should be necessary.

The ASSO is factory assembled with an internal air pressure of 20 bars (285 PSI). Warning : in case of re-loading do not ever exceed the 20 BAR.

To load an Asso you should lean the handgrip against your thigh or foot, according to the length, after inserting the tang of the shaft in the muzzle; drive the shaft to the end towards the handgrip until the piston is hooked to the click tooth (when the hook has taken place, one can hear the "click" of the tooth itself). Now the gun is ready for firing: slide the safety to the fire position and pull the trigger to shoot.

• Tank: aluminum alloy cylinder with a 40 mm diameter.
• Butt: Light alloy muzzle with increased holes to optimize the discharge of water.
• Handle: ergonomic and functional form. Made in one material.
• Barrel: the 13 mm diameter allows the use of an 8 mm spear.
• Comes with: steel spear, injector, harpoon, harpoon loader.

Seac-Sub Asso Pneumatic Speargun without Power Reducer has an aluminum alloy cylinder with a 40 mm diameter. Light alloy muzzle with increased holes to optimize the discharge of water the 13 mm diameter allows the use of an 8 mm spear. Comes with: steel spear, pump, Tip, Loader, line, carrying case.

Pneumatic Spearguns utilize the energy from compressed air stored in the barrel. They are usually more powerful than banded Spearguns of the same length. When the shaft is pushed into the barrel, it compresses the air and builds up pressure.

No Pumping is required between shots. Pumping air into the barrel with the pump supplied is only necessary if the working pressure has been reduced by expelling air i.e expelling air from the gun due to air travel etc. Most spear fisherman set the power / pressure at the start of the season - and that’s it! No more pressure setting or pumping should be necessary.

The ASSO is factory assembled with an internal air pressure of 20 bars (285 PSI). Warning : in case of re-loading do not ever exceed the 20 BAR.

To load an Asso you should lean the handgrip against your thigh or foot, according to the length, after inserting the tang of the shaft in the muzzle; drive the shaft to the end towards the handgrip until the piston is hooked to the click tooth (when the hook has taken place, one can hear the "click" of the tooth itself). Now the gun is ready for firing: slide the safety to the fire position and pull the trigger to shoot.

• Tank: aluminum alloy cylinder with a 40 mm diameter.
• Butt: Light alloy muzzle with increased holes to optimize the discharge of water.
• Handle: ergonomic and functional form. Made in one material.
• Barrel: the 13 mm diameter allows the use of an 8 mm spear.
• Comes with: steel spear, injector, harpoon, harpoon loader.

Seac-Sub Asso Pneumatic Speargun without Power Reducer has an aluminum alloy cylinder with a 40 mm diameter. Light alloy muzzle with increased holes to optimize the discharge of water the 13 mm diameter allows the use of an 8 mm spear. Comes with: steel spear, pump, Tip, Loader, line, carrying case.

Pneumatic Spearguns utilize the energy from compressed air stored in the barrel. They are usually more powerful than banded Spearguns of the same length. When the shaft is pushed into the barrel, it compresses the air and builds up pressure.

No Pumping is required between shots. Pumping air into the barrel with the pump supplied is only necessary if the working pressure has been reduced by expelling air i.e expelling air from the gun due to air travel etc. Most spear fisherman set the power / pressure at the start of the season - and that’s it! No more pressure setting or pumping should be necessary.

The ASSO is factory assembled with an internal air pressure of 20 bars (285 PSI). Warning : in case of re-loading do not ever exceed the 20 BAR.

To load an Asso you should lean the handgrip against your thigh or foot, according to the length, after inserting the tang of the shaft in the muzzle; drive the shaft to the end towards the handgrip until the piston is hooked to the click tooth (when the hook has taken place, one can hear the "click" of the tooth itself). Now the gun is ready for firing: slide the safety to the fire position and pull the trigger to shoot.

• Tank: aluminum alloy cylinder with a 40 mm diameter.
• Butt: Light alloy muzzle with increased holes to optimize the discharge of water.
• Handle: ergonomic and functional form. Made in one material.
• Barrel: the 13 mm diameter allows the use of an 8 mm spear.
• Comes with: steel spear, injector, harpoon, harpoon loader.

Seac-Sub Asso Pneumatic Speargun without Power Reducer has an aluminum alloy cylinder with a 40 mm diameter. Light alloy muzzle with increased holes to optimize the discharge of water the 13 mm diameter allows the use of an 8 mm spear. Comes with: steel spear, pump, Tip, Loader, line, carrying case.

Pneumatic Spearguns utilize the energy from compressed air stored in the barrel. They are usually more powerful than banded Spearguns of the same length. When the shaft is pushed into the barrel, it compresses the air and builds up pressure.

No Pumping is required between shots. Pumping air into the barrel with the pump supplied is only necessary if the working pressure has been reduced by expelling air i.e expelling air from the gun due to air travel etc. Most spear fisherman set the power / pressure at the start of the season - and that’s it! No more pressure setting or pumping should be necessary.

The ASSO is factory assembled with an internal air pressure of 20 bars (285 PSI). Warning : in case of re-loading do not ever exceed the 20 BAR.

To load an Asso you should lean the handgrip against your thigh or foot, according to the length, after inserting the tang of the shaft in the muzzle; drive the shaft to the end towards the handgrip until the piston is hooked to the click tooth (when the hook has taken place, one can hear the "click" of the tooth itself). Now the gun is ready for firing: slide the safety to the fire position and pull the trigger to shoot.

• Tank: aluminum alloy cylinder with a 40 mm diameter.
• Butt: Light alloy muzzle with increased holes to optimize the discharge of water.
• Handle: ergonomic and functional form. Made in one material.
• Barrel: the 13 mm diameter allows the use of an 8 mm spear.
• Comes with: steel spear, injector, harpoon, harpoon loader.